[Simulink相关] 设计的模糊控制器无法仿真 - MATLAB爱好者论坛-LabFans.com

怀念过往 · 2009-05-29, 17:15

我做的毕业设计要用到模糊控制器，我现在做好了，拉到Simulink里仿真的时候报错如下：1.untitled8/Fuzzy logic Controller/FIS wizard/Defuzzication1/Max(COA)
MinMax does not accept 'boolean' signals. The input and output signal(s) of 'untitled8/Fuzzy Logic Controller/FIS Wizard/Defuzzification1/Max (COA)' must be one of the MATLAB 'uint8', 'uint16', 'uint32', 'int8', 'int16', 'int32', 'single', or 'double' data types, or one of the Fixed-point data types
2.untitled8/Fuzzy logic Controller/FIS wizard/Defuzzication1/zero Strength(COA)
An error occurred while propagating data type 'boolean' from 'untitled8/Fuzzy Logic Controller/FIS Wizard/Defuzzification1/Zero Strength (COA)', output port 1请问我该在哪解决这个问题呢？

2009-05-29, 17:15	#1
怀念过往初级会员注册日期: 2009-05-29 年龄: 38 帖子: 1 声望力: 0	设计的模糊控制器无法仿真我做的毕业设计要用到模糊控制器，我现在做好了，拉到Simulink里仿真的时候报错如下：1.untitled8/Fuzzy logic Controller/FIS wizard/Defuzzication1/Max(COA) MinMax does not accept 'boolean' signals. The input and output signal(s) of 'untitled8/Fuzzy Logic Controller/FIS Wizard/Defuzzification1/Max (COA)' must be one of the MATLAB 'uint8', 'uint16', 'uint32', 'int8', 'int16', 'int32', 'single', or 'double' data types, or one of the Fixed-point data types 2.untitled8/Fuzzy logic Controller/FIS wizard/Defuzzication1/zero Strength(COA) An error occurred while propagating data type 'boolean' from 'untitled8/Fuzzy Logic Controller/FIS Wizard/Defuzzification1/Zero Strength (COA)', output port 1请问我该在哪解决这个问题呢？