MATLAB爱好者论坛-LabFans.com - 查看单个帖子

jiangsh1984 · 2008-03-11, 14:35

仿真时出现Warning: Using a default value of 0.2 for maximum step size. The simulation step size will be limited to be less than this value. You can disable this diagnostic by setting 'Automatic solver parameter selection' diagnostic to 'none' in the Diagnostics page of the configuration parameters dialog.
请问：这是什么原因，部分仿真出现此WARNING仍能得出仿真结果，但有的就不能进行仿真了,请问如何修改？？？
:sweat:

2008-03-11, 14:35	#1
jiangsh1984 初级会员注册日期: 2008-03-11 年龄: 40 帖子: 3 声望力: 0	【求助】simulink问题：Warning提示仿真时出现Warning: Using a default value of 0.2 for maximum step size. The simulation step size will be limited to be less than this value. You can disable this diagnostic by setting 'Automatic solver parameter selection' diagnostic to 'none' in the Diagnostics page of the configuration parameters dialog. 请问：这是什么原因，部分仿真出现此WARNING仍能得出仿真结果，但有的就不能进行仿真了,请问如何修改？？？ :sweat: